8516 Hybrid NVR with RAID Installation Guide
31
Unit Setup
3
Install the upper mounting screws at the marked locations.
•
If the upper mounting location is in a wall stud, thread the screw directly into the wall stud.
•
If the upper mounting location is in drywall, first install a drywall anchor, and then thread
the screw into the drywall anchor.
Do not thread the mounting screws all the way in. The screw heads should protrude
approximately 0.25 inches (0.64 centimeters) from the mounting surface so that you can hang
the docking station on them.
4
Lift up the docking station and hang it on the upper mounting screws. Do not tighten the
screws at this time.
5
Mark the locations of the two lower mounting holes.
6
Remove the docking station from the mounting screws and put it aside.
7
Install the lower mounting screws at the marked locations.
•
If the lower mounting location is in a wall stud, thread the screw directly into the wall stud.
•
If the lower mounting location is in drywall, first install a drywall anchor, and then thread the
screw into the drywall anchor.
Do not thread the mounting screws all the way in. The screw heads should protrude
approximately 0.25 inches (0.64 centimeters) from the mounting surface so the recorder can be
hung on them.
8
Hang the docking station on the mounting screws. The docking station drops approximately 0.5
inches (1.27 centimeters) when hung on the mounting screws. The screws lock into the
mounting hole keyways, providing a positive locking mechanism.
9
Tighten the mounting screws.
Mounting Screw
Docking
Station
