Maquet HCU 40, Инструкция по эксплуатации

Страница: 47 / 148

| HCU 40 | 4 Operation | 47 |
Instructions for Use | 1.0 | EN | 01
Copyright Maquet Cardiopulmonary GmbH
▶ The HCU 40 stops the activated pump and displays the [Pump not running]
symbol.
4.2.4 Using Hotkeys
The following instructions apply for the patient water circuit and the cardioplegia
water circuit. Hotkey
[Warm patient water circuit] is shown.
1 Touch a hotkey in order to use its values, e.g., [Warm patient water circuit] .
▶ The touchscreen displays the values
set for the hotkey: T
set
" for setpoint
temperature, [ΔT] for setpoint
gradient.
▶ The touchscreen displays a warning symbol if the setting may be harmful
to health (see table below).
2 Ensure that the selected setting is suitable and safe for the patient and the
current situation.
3 To confirm and use the displayed values, touch the [Confirm] symbol.
▶ In this case, the HCU 40 adopts the values of the hotkey as the setpoint
temperature and setpoint gradient.
▶ The setpoint gradient is only used if external temperature sensors are
connected. Gradient mode is deactivated with the value
[Off] .
Or
4 If you do not want to use the values, touch the [Reject] symbol instead.
Cause Message
Setpoint temperature
> 39.4°C Temperature setting may be harmful to health!
Setpoint temperature
< 33.0°C
Gradient > 8.0°C