Manitou MUSTANG 1050RT, Руководство оператора

Страница: 97 / 156

OPERATION
50950436
/
H0521
94 Printed in U.S.A.
After Operation
Park the machine on firm, level ground.
Raise the restraint bar to disable the
hydraulic controls.
Always apply the lift arm support if
leaving the machine with the lift arm in
the raised position Refer to “Lift Arm
Lift Support” on page 76.
If you must park on a slope or
an incline, park across the slope
and block the machine to prevent
movement.
If parking on a street, use barriers, cau-
tion signs, lights, etc. to increase the
visibility of the machine and prevent
collisions. This is especially important
at night, during bad weather and in
high-traffic areas.
After performing the”Mandatory Safety
Shutdown Procedure” on page 16, perform
the following tasks and checks:
• Fill the fuel tank . Refer to”Types of
Lubricants” on page 101 .
• Remove any dirt and/or debris from the
engine compartment .
• Remove any mud from the chassis . Clean
any dirt or water from the cylinder rod surfaces
to prevent corrosion and protect the cylinder
seals .
• If parking the machine for an extended
period, lock the cab door, the storage com-
partment, the battery and hydraulic filler
compartments and the engine compartment .
Take the keys with you .
Jump-Starting
If the battery becomes discharged or does not
have enough power to start the engine, use
jumper cables and the following procedure to
jump-start the engine .
The ONLY safe method for jump-start-
ing a discharged battery is for TWO
PEOPLE to perform the following pro-
cedure. The second person removes
the jumper cables so that the operator
does not have to leave the operator’s
compartment with the engine running.
NEVER make jumper cable connec-
tions directly to the starter solenoid
of either engine. DO NOT start the
engine from any position other than
on the operator’s seat and then ONLY
after being sure ALL controls are in
“neutral.”
Closely follow the procedure, in order,
to avoid personal injury. In addition, to
protect your eyes wear safety glasses
and avoid leaning over the batteries
while jump-starting.
DO NOT jump-start the battery if it is frozen,
because it may rupture or explode .
NOTE: BE SURE the jumper battery is a
12-volt D.C. battery.
1 . Turn the keyswitches of both vehicles to
OFF, be sure the vehicles are in “neutral”
and NOT touching each other .
2 . Connect the positive (+) jumper cable
to the positive (+) battery terminal on
the disabled machine first. DO NOT
allow the positive clamps to touch any
metal other than the positive (+) battery
terminals .