Manitou MUSTANG 1050RT, Руководство оператора

Страница: 79 / 156

OPERATION
50950436
/
H0521
76 Printed in U.S.A.
Lift Arm Lift Support
A falling lift arm could result in severe
injury or death.
If the lift arm must be left in the raised
position, BE SURE to properly apply
the lift arm support device.
The operator must not leave the
operator’s position if the lift arm is in
the raised position unless the lift arm
support device is properly applied.
A second person on the outside of
the machine is required to assist with
applying the lift arm support.
Engage Lift Arm Support
1 . Empty and remove the attachment .
2 . Bring the machine to a complete stop on a
level surface .
3 . Raise the lift arm as high as it will go .
4 . Move the drive controls to the neutral
position .
5 .
Shut off the engine.
The lift arm should remain in the raised
position when the engine is stopped.
If the lift arm is observed moving from
the raised position, stay in the oper-
ator’s position, lower the lift arm and
exit the machine. Have the machine
serviced by an authorized dealer before
operating again.
6 . Move the lift/tilt controls to verify that the
controls do not cause movement of the lift
arm and hitch plate .
7 . Raise the restraint bar to disable the
hydraulic controls .
8 . Stay in the machine sitting in the oper-
ator’s position . A second person, on the
outside of the machine, must:
a . Remove retaining fastener (L, Fig .
28) securing lift arm support (M) in the
storage position .
Fig. 28 -
M
L
Lift Arm Support Device in
Storage Position
b . Position the lift arm support (M, Fig .
29) over the lift arm cylinder rod (N, Fig .
29) .
Fig. 29 -
M
N
Lift Arm Support Applied
9 . Start the machine and lower the lift arm
against lift arm support (M) . Verify that
lift arm support (M) is properly posi-
tioned as shown in Fig . 29 .