Manitou MLA 628 -120 LSU 3-E2 Series, Руководство оператора

Страница: 107 / 130

3 - 27 3 - 27
D10 - C D10 - C
A AB B VE VENT NTIL ILAT ATIO ION N FI FILT LTER ER
CLEAN CLEAN
- Lift up protective casing 1 (fig. D10). - Lift up protective casing 1 (fig. D10).
- Lift out cabin ventilation filters 2 (fig. D10).
- Lift out cabin ventilation filters 2 (fig. D10).
- Clean the filter with a compressed air jet.
- Clean the filter with a compressed air jet.
- Check its condition and change if necessary (see : 3 - MAINTENANCE : FILTERS CAR-
- Check its condition and change if necessary (see : 3 - MAINTENANCE : FILTERS CAR-
TRIDGES AND BELTS). TRIDGES AND BELTS).
- Install the filters and protective casing. - Install the filters and protective casing.
D11 - B D11 - B
AT ATTE TERY RY ELE ELECT CTROL ROLYT YTE E DE DENSI NSITY TY
CHECK CHECK
The electrolyte density varies depending o The electrolyte density varies depending on the temperature concerned, n the temperature concerned, but a minimum of but a minimum of
1260 at 61°F must be 1260 at 61°F must be maintained. In the s maintained. In the shaded area (fig. D11), haded area (fig. D11), the battery is in a nor- the battery is in a nor-
mal charge condition. Readings above this zone indicate that the battery needs to be mal charge condition. Readings above this zone indicate that the battery needs to be
recharged.
recharged.
The density should not vary more than 0.025 units between cells.
The density should not vary more than 0.025 units between cells.
- Check the electrolyte density in each battery cell using a hydrometer. - Check the electrolyte density in each battery cell using a hydrometer.
- Do
- Do not carry out not carry out this check immediately after topping up with distilled this check immediately after topping up with distilled water water. Recharge the . Recharge the
battery for at least an hour before checking the battery electrolyte density. battery for at least an hour before checking the battery electrolyte density.
Handling and servicing a Handling and servicing a battery can be dangerous, t battery can be dangerous, t ake the following precautions ake the following precautions : :
- Wear protective goggles. - Wear protective goggles.
- Keep the battery horizontal. - Keep the battery horizontal.
- Never smoke or work near a naked flame. - Never smoke or work near a naked flame.
- Work in a well-ventilated area. - Work in a well-ventilated area.
- In the event of electrolyte being spilled onto the skin or splashed in the eyes, - In the event of electrolyte being spilled onto the skin or splashed in the eyes,
rinse thoroughly with cold water for 15 minutes and call a doctor. rinse thoroughly with cold water for 15 minutes and call a doctor.
1.240 1.240
1.250 1.250
1.260 1.260
1.270 1.270
1.280 1.280
1.290 1.290
1.300 1.300
° °
C C
° °
F F
-18 -18
0 0
-10 -10
14 14
0 0
32 32
10 10
50
50
20 20
68
68
30 30
86
86
40 40
104 104
D11 D11
D10 D10
2 2
2 2
1 1
Handling and servicing a battery can be dangerous, take the following precau- Handling and servicing a battery can be dangerous, take the following precau-
ti
tion ons s : :
- Wear protective goggles.
- Wear protective goggles.
- Keep the battery horizontal.
- Keep the battery horizontal.
- Never smoke or work near an open flame.
- Never smoke or work near an open flame.
- Work in a well-ventilated area.
- Work in a well-ventilated area.
- In the event of electrolyte being spilled onto the skin or splashed in the
- In the event of electrolyte being spilled onto the skin or splashed in the
eyes, rinse thoroughly with cold water for 15 minutes and call a doctor. eyes, rinse thoroughly with cold water for 15 minutes and call a doctor.
WARNING WARNING
D12 - F D12 - F
RO RONT NT A AN ND D R RE EA AR R A AX XL LE E D DIIF FFE FER RE ENT NTIIAL AL OI OIL L
DRAIN DRAIN
Park the lift truck on level ground with the I.C. engine stopped and the differential oil still Park the lift truck on level ground with the I.C. engine stopped and the differential oil still
warm.
warm.
Dispose the drain oil in an ecological manner. Dispose the drain oil in an ecological manner.
- Place a container under drain plugs 1 (fig. D12/1) and unscrew the plugs. - Place a container under drain plugs 1 (fig. D12/1) and unscrew the plugs.
- Remove level plug 2 (fig. D12/1) and filler plug 3 (fig. D12/1) in order to ensure that the
- Remove level plug 2 (fig. D12/1) and filler plug 3 (fig. D12/1) in order to ensure that the
oil is drained oil is drained properly properly..
- Install and tighten drain plugs 1 (fig. D12/1) (tightening torque 32 ft/lb). - Install and tighten drain plugs 1 (fig. D12/1) (tightening torque 32 ft/lb).
-
- Fill up with oil (see : Fill up with oil (see : 3 - MAINTENANCE 3 - MAINTENANCE : LUBRICANTS : LUBRICANTS AND FUEL) by AND FUEL) by filler port 3 (fig. filler port 3 (fig.
D12/1). D12/1).
- The level is correct when the oil level is flush with the edge of port 2 (fig. D12/1). - The level is correct when the oil level is flush with the edge of port 2 (fig. D12/1).
- Check for any possible leaks at the drain plugs.
- Check for any possible leaks at the drain plugs.
- Install and tighten level plug 2 (fig. D12/1) (tightening torque 32 ft/lb) and filler plug 3
- Install and tighten level plug 2 (fig. D12/1) (tightening torque 32 ft/lb) and filler plug 3
(fig. D12/1) (tightening torque 32 ft/lb). (fig. D12/1) (tightening torque 32 ft/lb).
- Repeat this operation for the rear axle differential (fig. D12/2). - Repeat this operation for the rear axle differential (fig. D12/2).
D12/1 D12/1
1 1
2 2
1 1 1 1
3 3
D12/2 D12/2
2 2
3 3
Dispose of the drain oil in an ecological manner. Dispose of the drain oil in an ecological manner.
IMPORTANT IMPORTANT
CONTENTS CONTENTS
https://www.forkliftpdfmanuals.com/