19
(1)
(2)
0.6 mm - 0.7 mm
(0.024” - 0.028”)
CHECKING THE SPARK PLUG
– Only use the supplied universal wrench to remove or to install the spark plug.
– The gap between the two electrodes of the spark plug should be 0.6 - 0.7 mm
(0.024” - 0.028”). If the gap is too wide or too narrow, adjust it. If the spark
plug is clogged or contaminated, clean it thoroughly or replace it.
Place the plug cap properly as illustrated after checking.
CAUTION: Never touch the spark plug connector while the engine is running
(danger of high voltage electric shock).
SUPPLY OF GREASE TO GEAR CASE
– Supply grease (Shell Alvania 2 or equivalent) to the gear case (1) through the
grease hole (2) every 30 hours. (Genuine MAKITA grease may be purchased
from your MAKITA dealer.)
CLEANING OF FUEL FILTER
WARNING: INFLAMMABLES STRICTLY PROHIBITED
Interval of inspection: Monthly (every 50 operating hours)
Suction head in the fuel tank
&KHFNWKHIXHO¿OWHUSHULRGLFDOO\7RFKHFNWKHIXHO¿OWHUIROORZWKHVWHSV
below:
1. Remove the fuel tank cap, drain the fuel to empty the tank. Check the tank
inside for any foreign materials. If any, remove them.
2. Pull out the suction head by using a wire hook through the tank opening.
,IWKHIXHO¿OWHUFORJJHGVOLJKWO\FOHDQLW7RFOHDQLWJHQWO\VKDNHDQGWDS
it in fuel. To avoid damage, do not squeeze or rub it. The fuel used for the
FOHDQLQJPXVWEHGLVSRVHGLQDFFRUGDQFHZLWKWKHPHWKRGVSHFL¿HGE\
regulations in your country.
,IWKHIXHO¿OWHUEHFDPHKDUGRUKHDYLO\FORJJHGXSUHSODFHLW
$IWHUFKHFNLQJFOHDQLQJRUUHSODFLQJLQVHUWWKHIXHO¿OWHULQWRWKHIXHOSLSH
DQG¿[LWE\WKHKRVHFODPS3XVKWKHIXHO¿OWHULQDOOWKHZD\WRWKH
bottom of the fuel tank.
&ORJJHGRUGDPDJHGIXHO¿OWHUFDQFDXVHLQVXI¿FLHQWIXHOVXSSO\DQGUHGXFH
HQJLQHSRZHU5HSODFHWKHIXHO¿OWHUDWOHDVWTXDUWHUO\WRHQVXUHVDWLVIDFWRU\IXHO
supply to the carburetor.
(1)
(2)
(3)
(1)