ANUFACTURING, INC. (714) 772-5202 FAX (714) 772-2302
ARROW MORTISE LOCK
HIT-45AW3 TEMPLATE GUIDE
FOR ARROW AM & BM SERIES MORTISE LOCKS WITH THRU-BOLTED ESCUTCHEON, WROUGHT AND
ROSE TRIM, USED IN CONJUNCTION WITH FACTORY PAPER TEMPLATE AND DIRECTIONS.
USE MARKED HOLES AS FOLLOWS:
(A) FOR ESCUTCHEON TRIM.
Drill only if using H escutcheon trim.
Template hole size: 3/8”, drill half way from both sides of door.
(B) FOR MORTISE CYLINDER
Drill only on side of door with a mortise cylinder.
Template hole size: 1/4”, drill only to mortise pocket.
Enlarge hole to 1-1/4” with a hole saw.
(C) FOR THUMB TURN
Drill only on side of door with a thumb turn.
Template hole size: 1/4”, drill only to mortise pocket.
Enlarge hole to 5/8” for rose trim or to 13/16” for escutcheon trim.
Hole “C” is also used on outside door if installing 02 privacy function.
Template hole size: 1/4”, drill only to mortise pocket.
Enlarge hole to 5/8” with a hole saw.
(D) FOR KNOB OR LEVER THRU-BOLT HOLES
Drill only on side of door with a knob or lever.
Template hole size: 3/8”, drill only to mortise pocket.
(E) FOR KNOB OR LEVER SPINDLE HOLE
Drill only on side of door with a knob or lever.
Template hole size: 1/4”, drill only to mortise pocket.
Enlarge hole to 7/8” with a hole saw.
(F) FOR SURFACE APPLIED WROUGHT TRIM.
Match trim to drill guide. Drill only if using wrought trim.
Drill template size is 1/16”. Redrill to proper diameter for wood or
Steel door. In wood door drill only to the length of screw used.
ALWAYS WEAR EYE AND EAR PROTECTION WHEN USING POWER TOOLS!
IMPORTANT: If using HIT-45 Clamp for faceplate routing you must remove
bevel blocks prior to drilling function holes. Failure to do so will result in
incorrect backset.
Содержание HIT-45
Страница 2: ...Use the HIT 45 clamp system to route faceplate openings in wood doors...
Страница 30: ...ANUFACTURING INC 714 772 5202 FAX 714 772 2302...
Страница 31: ......