ANUFACTURING, INC. (714) 772-5202 FAX (714) 772-2302
UNICAN SOLITAIRE MORTISE LOCK
HIT-45UN2 TEMPLATE GUIDE
FOR USE WITH 710/850/950 MORTISE LOCKS
USE MARKED HOLES AS FOLLOWS
(A) FOR THRU-BOLTED ESCUTCHEON TRIM
Drill only if using thru-bolted escutcheon trim.
Template hole size: 1/4”, drill half way from both sides of door.
Enlarge hole to 7/16” after all holes are drilled and HIT-45 has
Been removed from door.
(B) FOR PASSAGE CABLE
Template hole size: 1/4”, drill half way from both sides of door.
Enlarge hole to 1-1/4” with a hole saw after all holes are drilled
and HIT-45 has been removed from door.
(C) FOR PRIVACY FUNCTION
Drill only on side of door that the turn piece or emergency turn piece
is to be installed on.
Template hole size: 1/4”, drill only to mortise pocket.
Enlarge hole to 7/8” with a hole saw after all holes are drilled and
HIT-45 has been removed from door.
(D) FOR GUIDING POSTS FOR 710/850/950 ONLY
Drill holes only if using trim that requires mounting holes.
Not required on 710-11 to 715-11 series.
Template hole size: 1/4”, drill to mortise pocket from both sides
of door.
(E)
LEVER HOLE
Drill to mortise pocket from both sides of door.
Template hole size: 1/4”. Enlarge to 1-1/4” with a hole saw after all
Holes are drilled and HIT-45 has been removed from door.
(F) FOR MECHANICAL KEY CYLINDER OVERRIDE
Drill hole only when using mechanical key cylinder override on outside
of door. Template hole size: 1/4”. Enlarge to 1-3/8 x 1-1/4” deep
with a hole saw after all holes are drilled and HIT-45 has been removed
from the door.
VISIT OUR WEBSITE!
www.majormfg.com
ALWAYS WEAR EYE AND EAR PROTECTION WHEN USING POWER TOOLS!
IMPORTANT: If using HIT-45 Clamp for faceplate routing you must remove
bevel blocks prior to drilling function holes. Failure to do so will result in
Incorrect backset.
Содержание HIT-45
Страница 2: ...Use the HIT 45 clamp system to route faceplate openings in wood doors...
Страница 30: ...ANUFACTURING INC 714 772 5202 FAX 714 772 2302...
Страница 31: ......