31
LDVR Series Direct Vent Gas Fireplace
10007317
Lighting & Operating Instructions
For Fireplaces equipped with AF4000 Gas Valve
A. This fireplace is equipped with an ignition device which
automatically lights the pilot.
DO NOT
try to light the
pilot by hand.
B.
BEFORE OPERATING
, smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than the air and will settle on the
floor.
What to do if you smell gas
•
Do not try to light any appliance.
•
Do not operate any electrical switch.
For Your Safety, Read the Following Warnings
before Lighting the Appliance
•
Do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas suppliers instructions.
•
If you cannot contact your gas supplier call the
Fire Department
C. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and replace any part of the
control system and any gas control that has been under
water.
1. Turn the remote switch to the OFF position.
. Turn OFF all electrical power to the fireplace if service
is required.
3. Open the lower access panel.
4. Turn the shut-off valve on the flexible gas line to the
OFF position.
WARNING
If you do not follow these instructions exactly, a fire or explosion may result,
causing property damage, personal injury and loss of life.
Lighting Instructions
Turning Off the Gas to the Appliance
FP297A
INSTA VENT FREE
UVHB26 GAS SUPPLY
7/1/98
1/” Gas Supply
1/” NPT x 3/8” Flare
Shut-Off Valve
3/8” Flex Line
(From Valve)
Valve in the
“ON”
position
&0
!0VALVE
"
1.
STOP!
Read the safety information above before
continuing.
. This appliance is equipped with an ignition device
which automatically lights the pilot.
DO NOT
try to
light the pilot by hand.
3. Turn the remote switch, if used, OFF. Turn the
wireless remote, if used, OFF.
4. Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If you
smell gas, STOP. Follow instruction B in the
safety warnings above. If you do not smell
gas, go on to the next step.
5. Turn on electrical power to the appliance.
6. Turn remote switch or wireless remote to
ON.
7. If the appliance will not operate, follow the
instructions TURNING OFF THE GAS TO
THE APPLIANCE, and call your service
technician or gas supplier.
“S” Connection
Connect to Module
Spark to Pilot
Pilot Assembly
Pilot Gas Con-
nection
Side or Back
“I” Connection
Connect to
Module
Main Valve Internal
Solenoid Connec-
tion Green & White
Wires
Outlet
Pressure Tap
Pilot Internal Solenoid
Connection Orange & White Wires
Inlet Pressure
Tap
Pilot Adjustment
Screw
Black Plastic Cap
Flame Control
Knob
Minimum Rate Screw