7
LDVR Series Direct Vent Gas Fireplace
10007317
43LDVR
1. Place rear log (BD15) on rear bracket (ensure log is
centered and seated properly to the log support).
. Place front left log (BD16). Use log’s bottom notch to
locate it onto the front support and just rest on top of
the burner housing tile.
3. Place front right log (BD17). Use log’s bottom
notch to locate it onto the front support and
just rest on top of the burner housing.
4. Place ember material on top of burner.
5. Scatter the ember material over the tiles on
the front area of the burner housing. (Fig. 46)
Do not pack the ember material. Separate it
when unpacked and keep it in a fluffy and
loose condition for a more realistic ember ef-
fect.
6. Place front center log (B138) on top of the
two small shelves at the front log support,
and between the left and right logs.
7. Place top center log (BD18) on top of the rear log using
the hole locator under the log and on top of front right
log.
8. Scatter lava rock material round the firebox base.
Do not place any of the lava rock material on
the burner housing assembly.
RN/RP & EN/EP Models
For units equipped with “HI/LO” valves the flame adjustment
is accomplished by rotating the “HI/LO” adjustment knob
located near the center of the gas control valve. (Fig.
47)
Flame & Temperature Adjustment
It is important to periodically perform a visual check of the
pilot and burner flames. Compare them to the illustrations.
(Figs. 48 & 49)
If the flame patterns appear abnormal contact a qualified
service provider for service and adjustment.
Flame Characteristics
LO
HI
FP390
FLAME ADJUSTMENT KNOB
11/21/96
Turn
counterclockwise
to increase
flame height
Turn clockwise
to decrease
flame height
SIT 820 Valve
Fig. 47
Flame adjustment knob for SIT valve.
&0
3)4PILOTFLAMES
SIT RN/RP
SIT EN/EP, IN/IP
FP1541
Fig. 48
Correct pilot flame appearance.
,'
,$6LOGS
Rear
(BD15)
Top Center
(BBD18)
Front Right
(BD17)
Front
Left
(BD16)
Lava Rock
Front Center
(B138)
Ember Material
Lava
Rock
LG434
Figure 46
43LDVR