Maipu MP1800X-40, Руководство по установке

Страница: 34 / 65

Energization and Operation
MP1800X Series Router Installation Manual
4-6
copyright

2017Maipu, all rights reserved
Caution:

Before energizing the router, it is required to check the power supply switch in the
machine room where the switch is located, in order to cut off the power supply
immediately in case of an accident.
Energization
The steps to energize the router are:

T urn on the power supply switch of the router.
After the router is powered on and started, the configuration terminal displays some
loading information of the router:
Bootloader 1.38 for PR020_18_40-50 (May 12 2017 - 09:54:52)
DDR config clock: 800M
NAND: 512 MiB
PCI:
arm_clk=1000MHz, axi_clk=500MHz, apb_clk=250MHz, arm_periph_clk=500MHz
Net: bcmiproc_eth-0
Press ctrl+c to enter bootloader mode: 0
Use boot parameter 0:
device=flash0, file=rp37-7.3.0.58(R).pck
Copy flash/rp37-7.3.0.58(R).pck to 0x91007ed0 with size 22350568(0x1550ae8)
..................... [DONE]
Verifying Checksum ... OK
Uncompressing Linux... done, booting the kernel.
Starting init...Starting do before load ...
mount flash file system
done
Starting modules......done
Note:

The above displayed information on the start interface is just for reference. The actual
display prevails.
4.1.4
Post-energization Inspection
Energize the router. After loading all cards, check as follows to ensure that the later
configuration work can be done normally:

View whether the indicators on the router are normal.
Table 4-1 MP1800X-40E indicator description