14
Kleiss MCS7-2PVC System Manual
|
www.MainlineControlSystems.com
Retract the drilling rod and cutter completely into
the drilling dome. No part of the cutter should be
visible. (When retracted into the drilling dome,
the cutter should be in the position as shown in the
picture.)
Lock the drilling rod by operating the orange
tapping device lock.
With slide gate valve open (pulled out), install the
complete tapping tool onto the valve.
When doing this, make certain the valve doesn’t
inadvertently turn.
Position feed tube so it is flush with the bottom
thread.
Verify drilling dome bleed valve is closed.
