MAGUIRE Gravimetric Gateway LineMaster, Установка, эксплуатация и обслуживание

Страница: 40 / 93

Maguire Products, Inc.
40
LineMaster

LOCK Options
On the LineMaster (XCC) Controller keypad, between the up and down
arrows, is a LOCK key. This LOCK key can be used to Lock grams per length
(g/l), overriding the LineMaster Extruder Speed Control MANUAL / LOCK
switch. To use the keypad LOCK option, the LTP parameter in the
LineMaster (XCC) Controller must be set to LTP 1xxxx, where the first digit
in this parameter is set to a 1. Setting the LTP parameter to use this option
will de-activate (and ignore) the LineMaster Extruder Speed Control MANUAL
/ LOCK switch.
Shutdown
Normal Shutdown Procedure – First switch the
LineMaster Take-off Speed Control into
MANUAL position. Then rotate the ADJUST pot counterclockwise (at your desired rate of
decrease), eventually reaching zero line speed.
XC-3 – Yield D
XC-3 Multi-Layer Yield Control via Computer
XC-3 provides complete weight per length control (lb/ft or
gm/M), via simultaneous control of the extruder and take-off.
Controllers are connected via serial or Ethernet using the XC
Software. Gauge or thickness control can be initiated in set-up
utilizing data of the materials or blend specific gravity.
XC-3 (Yield-D) requires the G2 Software as the link
between the layers.
The following section is an overview of
the G2 software and will explain the use of G2’s Yield Screen
for XC-3 operation.
Linemaster
XCC Controller
Encoder, Encoder
Wheel
XCD-X Extruder
Drive Speed
Control
Take-Off
Speed Control