MAGUIRE Gravimetric Gateway LineMaster, Установка, эксплуатация и обслуживание

Страница: 31 / 93

Maguire Products, Inc.
31
LineMaster

XC-3 – Yield D Installation
The XC-3 kit involves the installation of the following components:

LineMaster Controller

Extruder Speed Control Interface

Take-off Speed Control Interface

LineMaster Cabling

Mounting hardware

24 Volt Power Supply

Encoder, Encoder Wheel (12 inch circumference)

Encoder Cable

G2 Software Cabling

Installation of G2 Software on dedicated PC (PC not included with kit)
Mount the XCD-X Extruder Drive Control in your desired location.
Mount the XCD-T Take-Off Drive Control in your desired location.
Remove the front cover from the Extruder Drive Control (see General
Installations Notes).
Run the Controller Cable from the LineMaster Controller’s 7-pin receptacle to
the Extruder Drive Control box. The un-terminated side of the cable will be on
the Extruder Drive Control box side and should be cut to length leaving
enough cable to run into the Extruder Drive Control box and to the terminal
strip.
Strip back approximately 2 ½ inches of the outer shielding from the un-
terminated side of the cable to expose the 5 wires. Run the Controller Cable
into the Extruder Speed Control Interface, through one of the two hole
locations on the Control box. Use a stain relief if necessary. Strip back
approximately ¼ inch (6mm) per wire and install into the terminal strip (see
wiring diagram on the following page for exact wire locations).
Install the Encoder on the shaft of the haul off. Run the Encoder signal cable
from the Encoder back to the XCD-X Extruder Drive Control. At the XCD-X
Extruder Drive Control wire the Encoder signal cable according to the wiring
diagram on the next page.
Run the Extruder Drive wire into the Extruder Speed Control Interface box and install into the
specified terminal strip as indicated in the wiring diagram.
If you are using the optional 24 volt power supply to power the
Extruder Speed Control Interface, install the power supply in a
desired location. Run a length of shielded, 2-conductor 18
gauge wire (not included in kit) from the power supply to the
Extruder Speed Control Interface and wire according to the
XC-1 Extrusion Control Wiring Diagram.