MAGUIRE Gravimetric Gateway LineMaster, Установка, эксплуатация и обслуживание

Страница: 23 / 93

Maguire Products, Inc.
23
LineMaster

General Wiring Installations Notes:
Wire Installations – Preventing Interference or Damage
When installing communication wires, be sure to avoid any sources of
interference such as vacuum loader lines (discharged static), high voltage
lines and transformers and florescent lights. You should avoid these
sources by a distance of a foot or more so that communication is not
disrupted by interference and sensitive electronic components are not
damaged.
To access the circuit board for the wiring installation, remove the 6
screws located on the face of the Extruder Speed Control or Take-
off Speed Control box.
If the wire installation into the Speed Control boxes will have an
exposed wire, use of a cable strain relief is recommended. Two
sizes of strain relief may be provided depending on your
application, one for single wire installations and one for 2 wire
installations. Two hole locations are provided in boxes, one at the
base and one on the back.
When installing wires onto the circuit board within the control
boxes, strip the outer wire insulation back approximately 2.5
inches (63mm) and the inner individual wire insulation back
approximately ¼ inch (6mm) per wire.
This recommendation is to prevent wires from shorting with each
other or internal electronic components.
Each application (Extrusion Control, Yield-X, Yield T or Yield D)
has a unique wiring diagram in the installation section of this
manual.
Refer to the provided wiring diagrams within this manual for
exact wire locations for your application.
Use of a 24-volt power supply. If you are using the 24-volt power
supply to power your control boxe(s), follow the wiring diagram
provided with the 24 volt power supply for specific wire attachment
locations. For demonstration purposes the images in this manual
are wired with the Brown wire attached to the +24 volt and the blue
wire attached to the common.