Maguire Products VBD-1000, Установка, эксплуатация и обслуживание

Страница: 47 / 85

Maguire Products, Inc.
Rev. March 5, 2018 – VBD-1000 Touchscreen
47
VBD

- Vacuum Dryer

RMP Temperature Ramp Settings (Increments/Minute/Degrees) – 52036
Format: XYYZZ - X = number of increments, YY = duration of ramp in minutes,
ZZ = temperature delta
For example, with RMP set to 52020: When temperature ramping is turned on, over
the course of 20 minutes, a 20 degree C camp will occur, in 5 increments of 4
degrees C.
CTM Cool-Down Temperature – Degrees - 00120 Fahrenheit or 00050 Celsius
Cool-down target temperature for the heat hopper during the Planned Shutdown.
CTR Cool-Down Timer – Minutes - 00030
Targeted elapsed time to cool-down target temperature (CTM parameter).
Load Cell Parameters
KDF Loadcell Stable Weight – counts – 00006
Maximum allowable fluctuation in raw loadcell counts to produce a stable weight
reading.
LST Loadcell Stable Time – milliseconds – 00100
Duration in milliseconds that raw loadcell counts must remain within KDF to
produce a stable loadcell reading.
LCZ Loadcell Zero – counts – 01000
Minimal allowable counts when zeroing load cells.
WST Weight Settle Time – seconds – 00005
Delay time in seconds after the vacuum chamber fill valve closes to allow material
to settle and the dryer to acquire an accurate weigh reading.
LZ1 Load Cell 1 Zero – counts – 00000
Factory set reference point in counts for retention hopper load cell. This parameter
should not be changed unless directed by a Maguire technician or if load cells are
replaced. If load cells are replaced, instructions will be provided. When this
parameter is set to zero (00000), restriction on loadcell calibration is disabled.
LZ2 Load Cell 2 Zero – counts – 00000
Factory set reference point in counts for vacuum chamber load cell. This
parameter should not be changed unless directed by a Maguire technician or if load
cells are replaced. If load cells are replaced, instructions will be provided. When
this parameter is set to zero (00000), restriction on loadcell calibration is disabled.