MCP-601 Operator’s Manual
Magni Systems, Inc.
17
Rear Panel Description
1
2
3 4 5 6 7 8 9 10 11
12
13 14 15 16 17 18 19 20
Figure 2-3. MCP-601 Rear View
The following cable connectors can be viewed from the rear of the MCP-601.
1.
Power
entry connector and fuse holder (1 amp time delay/slow blow) with spare included.
2.
RS-232
input for control (9 pin Dsub).
3.
USB
input for control
4.
Magni
FX-1 controller
connector (8 pin female RJ45 jack).
5.
SDI Input
. (Serial Digital 601, internal 75
Ω
terminations).
6.
SDI Key
output for external or downstream keying with a SDI switcher.
7.
Composite input
,
Y input
for Y/C or Y input for Component video (internal 75
Ω
termination).
8.
C input
for Y/C or
B-Y input
for Component video (internal 75
Ω
terminations).
9.
R-Y input
for Component video (internal 75
Ω
termination).
10.
VGA graphics input
with active loop through output. Plug and Play compatible.
11.
REF IN/CPST 2
, Reference input (analog output Subcarrier Phase referenced to REF IN
when selected) or as CPST 2, a second Composite input in Analog mode. The two
connectors form a high impedance video loop through that is not directional. In non-loop
through mode, one connector must be terminated in 75 ohms.
12.
Fan air outlet.
13.
SDI output
.
14.
Second
SDI output
in parallel with the other output (13).
15.
Analog Key output
for external or downstream keying with an analog switcher.
16.
Composite output
, Y output for Y/C or Y output for Component video.
17.
C output
for Y/C or
B-Y output
for Component video.
18.
R-Y output
for Component video.
19.
VGA monitor
output drive with active loop through from VGA input (10).
20.
DVI
Graphics input (internal 50
Ω
nominal termination). Plug and Play compatible.
NOTE:
1: You can connect one SDI input plus only one analog video format input at a time (Composite, S-
Video, or Component Y/R-Y/B-Y). Only one input can be selected at a time. Two SDI outputs and only
one analog video format output can be connected at a time. However, both SDI and analog outputs
are available simultaneously.
2: You can connect one DVI and one VGA input at the same time. Only one can be selected to be
scan-converted at a time.