Magnescale MG80-SC1, Руководство по эксплуатации, Страница: 25 / 51

24 / 48
Setup
parameter
area
By turning the parameter update flag ON, the setup parameters can be loaded into this memory area of the MG80-
SC. The data structure is shown below. There are setup parameters for each measurement axis number (counter
module ID).
Offset Data name Operation command
0x0000 Preset (low order)
①②
P=XXX
0x0001 Preset (high order)
0x0002 Comparator lower limit (set 1 low order)
①②
CL1=XXX
0x0003 Comparator lower limit (set 1 high order)
0x0004 Comparator upper limit (set 1 low order)
①②
CH1=XXX
0x0005 Comparator upper limit (set 1 high order)
0x0006 Comparator lower limit (set 2 low order)
①②
CL2=XXX
0x0007 Comparator lower limit (set 2 high order)
0x0008 Comparator upper limit (set 2 low order)
①②
CH2=XXX
0x0009 Comparator upper limit (set 2 high order)
0x000A Comparator lower limit (set 3 low order)
①②
CL3=XXX
0x000B Comparator lower limit (set 3 high order)
0x000C Comparator upper limit (set 3 low order)
①②
CH3=XXX
0x000D Comparator upper limit (set 3 high order)
0x000E Comparator lower limit (set 4 low order)
①②
CL4=XXX
0x000F Comparator lower limit (set 4 high order)
0x0010 Comparator upper limit (set 4 low order)
①②
CH4=XXX
0x0011 Comparator upper limit (set 4 high order)
0x0012 Comparator group number
①②
SCN=X
0x0013 Output value mode
①②
MODE=X