S
Section 3
7
Fig. 19
Ground (–) lead
(black)
Positive (+) lead
(red)
Ignition-Switched Fuses
Charging Cradle Cord
Radio
Heater
Accessory
Note:
For maximum protection of recharging
unit, it is recommended that a 1-amp fuse be
installed in the (+) red lead.
Charging Cradle
Direct Wire–Vehicle Installation 12–14 Volt Only (Not for 24-Volt Systems)
A 4’ power accessory cord is available to facilitate the direct-wiring of the rechargeable system (Fig. 19). Mag Instrument recommends
using only an ignition-switched (fused) circuit, and preferably the lowest output available (5 amps or less). This is most often the radio
or accessory fuse. The red (positive) lead is connected to the fuse output, and the black (negative) ground wire should be attached to a
metal part of the chassis, which serves as a battery ground return.
Installation
1 AMP
(
See Note)
A Typical Installation
1.
Locate and mount the cradle using appropriate screw and anchors for
the location and material.
2.
Attach end of DC power cord or AC converter to charging cradle by
inserting round plug into power connection port in the side of the
charging cradle.
Note:
When disconnecting plugs, grasp the plug body itself; never pull
on cord.
O
CAUTION:
Make sure cable cannot be pinched.
If cable is pinched it can
cause immediate short and wires can get hot, melt plastic, and create a
fire hazard.
Fig. 11
Power connection port
421_493_Rech_Man_LED_WHS_0320.qxp_Layout 1 4/5/21 9:35 AM Page 8
