Mackie 56-input, Быстрый старт

Страница: 13 / 43

D i g i t a l 8 • B u s
12
Assigning Channels 3 and 4 to Tracks 3 and 4.
• Make sure Fader Bank 1 is selected (1–24
MIC/LINE).
SHIFT MASTERS
1 - 24
25 - 48
49 - 72
(TRACK) (MONITOR)
BANK SELECT
EFFECTS
MIC/LINE
TAPE IN
• Press the ROUTE TO TAPE button in the
Bus Assignment Section.
BUS 1 BUS 2
BUS 3 BUS 4
BUS 5
BUS 7
BUS 6
BUS 8
L-R ROUTE TO
TAPE
ASSIGNMENT
ASSIGN ASSIGN
ASSIGN ASSIGN
ASSIGN ASSIGN
ASSIGN ASSIGN
ASSIGN ASSIGN
• Press the SELECT button on channel 3.
• Press the ASSIGN button on channel 3.
Channel 3 is now assigned to Tape Out 3, which
goes to Track 3 on your multitrack recorder.
• Press the SELECT button on channel 4.
• Press the ASSIGN button on channel 4.
Channel 4 is now assigned to Tape Out 4, which
goes to Track 4 on your multitrack recorder.
Next, assign channels 27 and 28 (which are
Tape Out 3 and 4 from the multitrack) to the
Left/Right Bus:
• Press the MASTER L-R button in the Bus
Assignment Section.
BUS 1 BUS 2
BUS 3 BUS 4
BUS 5
BUS 7
BUS 6
BUS 8
L-R ROUTE TO
TAPE
ASSIGNMENT
ASSIGN ASSIGN
ASSIGN ASSIGN
ASSIGN ASSIGN
ASSIGN ASSIGN
ASSIGN ASSIGN
• Select Fader Bank 2 (TAPE IN 25–48).
SHIFT MASTERS
1 - 24
25 - 48
49 - 72
(TRACK) (MONITOR)
BANK SELECT
EFFECTS
MIC/LINE
TAPE IN
• Press the ASSIGN buttons on channels 27
and 28 to assign them to the Left/Right bus.
Now arm tracks 3 and 4:
• Select Fader Bank 1 (MIC/LINE 1–24).
SHIFT MASTERS
1 - 24 25 - 48
49 - 72
(TRACK) (MONITOR)
BANK SELECT
EFFECTS
MIC/LINE TAPE IN
• Press the REC/RDY buttons on channels 3
and 4 to arm the tracks for recording, or
press the corresponding buttons on the tape
recorder.
• Start playing the keyboard. The meter
indications on the tape recorder should be
equivalent to the meter indications on the
console.
Important: The channel
faders do NOT set output
levels to the recorder. If the
meter indications on the
recorder are too high or too
low, you can adjust the
levels by pressing the LEVEL TO TAPE
button in the V-Pot Select Section. The
channel V-Pots become level controls for the
tape outputs. Adjust the V-Pots so the meter
indication on the tape recorder is at its
recommended level.
Next, get signal from the tape back to the console
and out the Control Room speakers (or
headphones):
• Put your multitrack recorder into Record/
Pause mode. This will allow the signal to
pass through the recorder and back to the
console.
TRIM
12
12
36
12
36
10
dB
30
20
10
40
5
5
U
60
50
FX 12
MIDI 4
MIC
0 60
-
20dB +40dB
LINE
ASSIGN
WRITE
MIC
REC/RDY
SELECT
MUTE
SOLO
Tutorial Hookup — Let’s Get It Working