MacDon M205, Руководство оператора

Страница: 218 / 514

214603
198
Revision A
a. Using FLOAT SELECTOR switch (B), push + to increase float or
–
to decrease float on left side of
header. CDM display (A) will indicate selected float for left side, for example, (5.0 L FLOAT R XX.X).
b. Repeat for right side float with switch (C). Display will indicate float for both sides, for example,
(5.0 L FLOAT R 5.0).
6. Shut down engine, and remove key.
7. Grasp the end of the header and lift. The force to lift should be as noted in the following table and should be
approximately the same at both ends.
Header Force Required to Lift Header at the Ends with Lift Cylinder Fully Retracted
Auger 335
–
380 N (75
–
85 lbf)
Rotary disc 426
–
471 N (95
–
105 lbf)
Draper 335
–
380 N (75
–
85 lbf) with stabilizer/transport wheels raised (if equipped)
Adjusting Float Using Drawbolts
Coarse float adjustment is done using the drawbolts located on either side of the windrower.
If necessary, coarse adjust the float with the drawbolts as follows:
CAUTION
Check to be sure all bystanders have cleared the area.
1008946
A
Figure 4.68: GSL
1. Start the engine.
2. Using HEADER UP (A) switch on the ground speed
lever (GSL), raise the header fully, shut down the
engine, and remove the key.
OPERATION