MacDon M205, Руководство оператора

Страница: 126 / 514

214603
106
Revision A
Setting the Engine Intermediate Speed Control (ISC) RPM
NOTE:
The ISC sets the engine speed when the header is engaged. For more information, refer to Engine Intermediate
Speed Control (ISC), page 166 .
The engine MUST be running to perform this procedure.
1009974
C###
X###
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.102: M205 CDM Programming Buttons
1. Start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the
upper line.
•
NO/YES is displayed on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1023538
SET ENGINE ISC RPM?
NO/YES
C###
X###
B
A
Figure 3.103: M205 Engine ISC RPM
4. Press SELECT (B) until SET ENGINE ISC RPM? is
displayed on the upper line.
•
NO/YES is displayed on the lower line.
5. Press right arrow (A) to select YES. Press SELECT (B).
•
PRESS HAZARD TO SET is displayed on the
upper line.
•
ISC RPM #### is displayed on the lower line.
Table 3.1 ISC Settings
ISC and RPM
Off 15 1 2 3
High Idle 2000 1800 1600
NOTE:
The previously selected ISC rpm will be flashing.
OPERATOR
’
S STATION
15. Off is always used when the header is not engaged.