MAC215986
411
Revision A
1032009
A
Figure 4.261: Draper Tensioner
4.
Tighten the draper by turning adjuster bolt (A) clockwise.
For instructions, refer to
5.
Disengage the reel and header safety props.
WARNING
Check to be sure all bystanders have cleared the area.
6.
Start the engine and lower the header and the reel.
7.
Run machine to verify that draper tracks correctly. Refer to
4.12.4 Adjusting Side Draper Tension, page 402
if additional
adjustment is necessary.
4.12.10
Removing Side Draper Drive Roller
The side draper deck has a roller on either end of the deck. One is the idler roller and one is the drive roller.
DANGER
To prevent injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and remove
the key from the ignition before leaving the operator
’
s seat or making adjustments to the machine. Never work on or
beneath an unsupported header. If the header is fully raised, always engage the safety props. If the header is off of the
ground but not raised to its full height, place blocks under the header.
DANGER
Ensure that all bystanders have cleared the area.
1.
If the draper connector is not visible, engage the header until the connector is accessible (preferably close to the
outboard end of the deck).
2.
Start the engine.
3.
Raise the header fully.
4.
Raise the reel fully.
5.
Shut down the engine, and remove the key from the ignition.
6.
Engage the reel safety props. For instructions, refer to the header operator
’
s manual.
7.
Engage the header safety props. Refer to the combine operator
’
s manual for instructions.
