MAC215986
116
Revision A
3.8.4
Setting Auger Position
The auger position has two settings: floating and fixed. The factory setting is the floating position, and is recommended for
most crop conditions.
1028427
A
A
Figure 3.137: Auger Float Adjustment Arms
Auger float adjustment arms (A) are located at the bottom left
and bottom right of the float module.
1020720
A
B
C
Figure 3.138: Auger Float Positions
If bolt (A) is next to floating symbol (B), the auger is in the
floating position. If bolt (A) is next to fixed symbol (C), the auger
is in the fixed position.
CAUTION
Make sure left and right brackets are set to the same position;
two bolts (A) must be in the same location to prevent damage
to the machine during operation.
DANGER
To prevent bodily injury or death from the unexpected start-up
or fall of a raised machine, always stop the engine, remove the
key, and engage the safety props before going under the header
for any reason.
To set the auger position, follow these steps:
1.
Start the engine. For instructions, refer to the combine operator
’
s manual.
2.
Raise the header fully.
3.
Engage the header
’
s safety props. For instructions, refer to the combine operator
’
s manual.
4.
Shut down the engine, and remove the key from the ignition.
