Hardware Included
Tools Included
4 Hex Wrenches (3, 4 ,5, 8 mm)
3 10mm Flat Washer
1 10mm Lock Washer
1 Jointer Mounting Bolts
Hardware Included
Tools Included
K Belt Guard Lock
M Push Blocks*2
L Switch Emergency stop Paddle
J Fence
Handle
I Knife Setting Jig
6
1 Stand with Motor and Switch
B Fence Carriage Assembly
G Handwheel Handles*2
H V-Belts*2
F Handwheels*2
E Belt
Guard
D Dust Chute
C Cutterhead
Guard
A Fence
Jointer-Body Assembly(Not shown)
Jointer Body Crate Contents
Jointer Body Crate
Stand Carton(Not shown in picture)
Note: Unit shipped in one crate and one carton.
Unpacking and Cleanup
Contents of Shipping Cartons
1 12/14mm Open End Wrench
1 8/10mm Open End Wrench
Tools Required for Assembly:
#1 Cross Point Screwdriver
6-8” Adjustable Wrench or 17 & 19mm Wrench
Unpacking and Cleanup
1. Carefully finish removing all contents from
both shipping cartons. Compare contents of
the shipping cartons with the list of contents
above. Place parts on a protected surface.
2. Set packing material and shipping cartons to
the side. Do not discard until machine has
been set up and is running properly.
3. Clean all rust protected surfaces (bed,
fence, etc.) with kerosene or diesel oil. Do
not use gasoline, paint thinner, mineral
spirits, etc. These may damage painted
surfaces.
