4. Mount handle (C, Fig. 3) onto handwheel.
3. Re-install screw and washer (B, Fig. 3).
2. Press handwheel (A, Fig. 3) onto shaft,
Figure 3
7
in jointer body assembly(Fig. 1)
place bed assembly on top of stand.
Cutterhead knives are
dangerously sharp! Use
extreme caution when cleaning.
4. Apply a thin layer of paste wax to the bright
surfaces of the fence and tables to prevent
rust.
Installing Bed to Stand
1. Use an assistant or hoist mechanism to
2. Line up two holes in top of stand with holes
3. Attach bed assembly to stand with two 3/8"
lock bolts and lock washers (Fig. 2). Hand
tighten only at this time.
4. Line up third hole in stand with hole in bed
assembly by viewing through dust chute.
5. Install third 3/8" lock bolt and lock washer
through dust chute to secure bed to stand.
6. Tighten all three mounting bolts with 14mm
wrench.
Figure 1
Figure 2
Installing Handwheels
1. Remove protective tape from shaft, and
remove screw and washer.
aligning the keyway with the key. If
necessary, use a hammer with a block of
wood to tap the handwheel completely onto
the shaft.
