9
(Fig. 5) on the mounting plate and push
is too loose, loosen the motor mounting bolts
aligned, loosen the bolts (A, Fig. 6) on the
Figure 6
cutterhead pulley are vertically aligned(Fig.5)
6. Check to make sure that motor pulley and
(Fig. 5)
sioning the v-belt with the weight of the motor.
Figure 5
5. Carefully allow the motor to slide downward
place v-belt onto motor pulley grooves,ten-
4. In stand, lossen the motor mount bolts.
motor mount bolts.
Note-DO NOT completely remove the
guard (B, Fig. 4).
2. Remove the lock knob (A, Fig. 4) and belt
Figure 4
Installing V-Belts
1. Disconnect the machine from the power
source, unplug.
3. Place v-belts onto cutterhead pulley grooves
and through opening in stand.
the v-belt does not contact the sides of the
opening in the base. If the pulleys are not
motor base and slide the motor until the belt
is aligned. Re-tighten screws.
6. The v-belt is properly tensioned when finger
pressure on the belt half way between the
two pulleys causes 1/2" deflection. If the belt
down on the plate. When belt tension is
correct, re-tighten screws.
7. After two hours of operation, check belt
tension again. Re-tension if necessary.
8. Re-install belt guard and lock knob.