USER MANUAL
PrestoAdvancedAD101_AD301_UG_000_UK
Descriptions and non-contractual illustrations in this document are given as an indication only.
M2M Design reserves the right to make any modification
42
Flow control
Flow control manages data flow between devices in a network to ensure it is
processed efficiently. Too much data arriving before a device is prepared to
manage it causes lost or retransmitted data. None is the default.
Protocol
Choose which protocol to use [TCP/UDP].
Mode
Select server mode in order to listen for incoming connection, or client mode to
establish one.
Bind to TCP/UDP port
Number of the TCP/UDP port to accept connections for this device. (Only on
server side)
Server IP address
Specify server IP address. (Only on client side)
Connect to TCP/UDP
port
Number of the TCP/UDP port to accept connections from this device. (Only on
client side)
Type of socket
Either
raw or telnet
. Raw enables the port and transfers all data like between the
port and the log. Telnet enables the port and runs the telnet protocol on the
port to set up telnet parameters.
Enable local echo
Enable the local echo feature.
Check TCP connection
Enable connection checking.
Kepalive idle time
Set keepalive idle time in seconds.
Kepalive interval
Set time period between checking.
Log level
Set importance level of log messages.
Reload
Click
Reload
to discard any changes and reload previous settings.
Save
Click
Save
button to save your changes back to the PRESTO Advanced Router
and activate/deactivate serial to Ethernet converter.
Table 15 – Ser2IP parameters
Click
Serial Port
Tab to open the Serial Port Configuration screen. Use this screen to configure the
PRESTO Advanced Router serial port parameters (
Figure 20
).
