USER MANUAL
PrestoAdvancedAD101_AD301_UG_000_UK
Descriptions and non-contractual illustrations in this document are given as an indication only.
M2M Design reserves the right to make any modification
34
Authentication setting.
NOTE: If you select a NULL method of authentication, the previous Phase 2 Encryption
method cannot be NULL.
Phase 2 SA Life Time
Configure the length of time an IPSec tunnel is active in Phase 2. The default is
3600 seconds. Both ends of the IPSec tunnel must use the same Phase 2 SA Life
Time setting.
Preshared Key
This specifies the pre-shared key used to authenticate the remote IKE peer. Enter
a key of keyboard and hexadecimal characters, e.g., Ay_%4222 or 345fa929b8c3e.
This field allows a maximum of 1023 characters and/or hexadecimal values. Both
ends of the IPSec tunnel must use the same Preshared Key.
NOTE: It is strongly recommended that you periodically change the Preshared Key to
maximize security of the IPSec tunnels
.
Local Security gateway
type
When
SIM Card
is selected the WAN (or Internet) IP address of the Router
automatically appears. If the Router is not yet connected to the GSM/UMTS
network this field is without IP address.
IP Address From
Select SIM card over which the tunnel is established
Local ID Type
How the of the participant should be identified for authentication; Can be an IP
address, fully-qualified domain name (FQDN) or User FQDN name preceded by
@ .
Local Security Group
Type
Select the local LAN user(s) behind the Router that can use this IPSec tunnel.
Select the type you want to use: IP or Subnet.
NOTE: The Local Security Group Type you select should match the Remote Security
Group Type selected on the IPSec device at the other end of the tunnel.
IP Address
Only the computer with a specific IP address will be able to access the tunnel.
Subnet Mask
Enter the subnet mask.
Remote Security
Gateway Type
Select the remote LAN user(s) behind the Router at the other end that can use this
IPSec tunnel. Select the type you want to use: IP or Subnet.
NOTE: The Remote Security Group Type you select should match the Local Security
Group Type selected on the IPSec device at the other end of the tunnel.
IP Address
Only the computer with a specific IP address will be able to access the tunnel.
Remote ID type
How the of the participant should be identified for authentication; Can be an IP
address, fully-qualified domain name (FQDN) or User FQDN name preceded by
@
Remote Security Group
Type
Select the remote LAN user(s) behind the Router at the other end that can use this
IPSec tunnel. Select the type you want to use: IP or Subnet.
NOTE: The Remote Security Group Type you select should match the Local Security
Group Type selected on the IPSec device at the other end of the tunnel.
IP Address
Only the computer with a specific IP address will be able to access the tunnel.
Subnet Mask
Enter the subnet mask.
Enable tunnel failover
Enable tunnel failover. If there is more than one tunnel defined, this option will
failover to other tunnel in case that selected one fails to established connection.
Ping IP
IP address on other side of tunnel which will be pinged in order to determine
current state.
Ping interval
Specify time period in seconds between two ping
