USER MANUAL
PrestoAdvancedAD101_AD301_UG_000_UK
Descriptions and non-contractual illustrations in this document are given as an indication only.
M2M Design reserves the right to make any modification
10
Product Overview
Front panel
On the front panel (
Figure 1
) the following connectors are located:
one RJ45 connector – Ethernet port for connection into local computer network;
one RJ45 connector for RS232 serial communication;
reset button;
one USB connector for connection of additional device;
Power supply connector.
Ethernet connector LED:
ACT (yellow) on – Network traffic detected (off when no traffic detected).
Network Link (green LED) on - Ethernet activity or access point engaged.
Figure 1 - PRESTO Advanced Router front panel
The Reset button can be used for a warm reset or a reset to factory defaults.
Warm reset:
If the
PRESTO Advanced
Router is having problem connecting to the Internet, press
and hold the reset button for a second using the tip of a pen.
Reset to Factory Defaults:
To restore the default settings of the PRESTO Advanced Router, hold the
RESET button pressed for a few seconds. Restoration of the default configuration will be signaled by blinks
of the first and last signal strength LED on the top panel. This will restore the factory defaults and clear all
custom settings of the PRESTO Advanced Router. You can also reset the PRESTO Advanced Router to
factory defaults using the Maintenance > Default Settings screen.
Back panel
On the back panel of device (
Figure 2
and
Figure 4
) the following connectors are located:
slot for SIM cards;
SMA connector for connection of the GSM/UMTS antenna;
Figure 2 - PRESTO Advanced Router back panel (GPRS and EDGE) AD101
