Lutz Easyzon D 100, Инструкция по установке, эксплуатации и обслуживанию

Страница: 18 / 45

Section 6: Installation
P a g e | 15
6.3 Cable & Tube Entry System
The
Easyzon D
uses an entry system located on the
right-hand side of the cabinet for routing cables into
the control panel.
New cable routing steps:
1.
Insert the cable(s) through the preferred inlay
section
[2] of the entry system that is fitted
inside the frame [1].
2.
Remove trunking covers and route cable/s
through each section and hole in the cabinet
door.
3.
Choose a suitable gland on the control panel to
run the cable/s through, use the electrical
diagram to wire in to the correct terminals on
the
Easyzon D P
CB.
4.
Select a seal insert from the kit provided with
the correct number of holes and diameter for
the cable/s (see section 6.3.1). Spread open
the insert
[3] and place it around the cable/s on
the inside of the cabinet, close to the entry
system.
5.
Push the seal insert all the way into the inlay
section.
✓
Cable routing complete
6.3.1 Seal Insert Selection
An array of varying diameter seal inserts is supplied
with the
Easyzon D
, ready to be used with a range of
tubes and cables. Additional inserts can be purchased
if required, see section 11.4 for spares.
Description
1 Entry frame
2 6
– way frame inlay
3 Seal insert