Wallbox Power Module Installation and Operation Guide 10
®
DALI Setup
Addressing DALI Devices
The “Address All” command can be used to add/replace DALI devices on the system
without running the “Build System” command (this avoids erasing all the existing
programming information).
The “Address All” command will treat replacement DALI devices as completely new
devices added to the system, increasing the total device count with every new/
replacement device.
Note:
If the system already contains 64 DALI devices, the only way to replace a
device is through the “Build System” command.
1. Enter programming mode.
2. Use the Master buttons to highlight “DALI” and press the OK
button to accept.
3. Use the Master buttons to highlight “Address All” and press
the OK button to accept.
All DALI devices in the system will
go to full On. As each DALI device is addressed, the Wallbox
Power Module control unit will display information about it,
and the device will go to its low-end. This will take several
minutes. The system will then return to the main menu.
4. To program new/replacement devices, follow the instructions
to assign DALI devices to a zone.
5. Exit programming mode.
6. The Wallbox Power Module with DALI Control Unit cannot
be controlled by the system until it is programmed using the
system programming software.
Main menu
Zone setup
Zone setup
DALI
Assign zone
Address All
DALI
Address All
Address All ?
Press OK
OK
1
2
3
4
5
6
9
10
11
12
13
14
7
8
15
16
9-16
1-8
Master
buttons
OK
button
Searching...
x
Found
x Loads
Found
