Application Note #480
18
www.lutron.com
Restoring Default Settings
The sensor dimmer has the ability to be returned to its original factory settings. This ability allows the programmer a
risk-free experience to try multiple setting styles without worry.
Note:
The default settings are:
Preset Light Level ........................................................ Unlocked Preset (all Indicator Lights turned OFF)
Manual Fade ON Time ................................................. 0.75 seconds
Manual Fade OFF Time ............................................... 2.5 seconds
Delayed Fade to OFF ................................................... 30 seconds
Enable / Disable Indicator Lights .................................. On
Low-End Trim ............................................................... IL2
High-End Trim .............................................................. IL7 (highest High-End Trim)
Auto Fade ON Time (not adjustable) ........................... 0.50 seconds
Timeout Fade OFF Time (not adjustable) .................... 10 seconds
To Restore Factory Defaults:
1.
Pull the FASS
T
into the
OFF
Position
(OUT), and
Wait 5 seconds
.
2.
Press and Hold
the
Tap
button. While continuing to hold the Tap button,
Push the FASS
T
to the
ON
Position
(IN)
and continue to
Hold the Tap
button for
approximately 15 seconds
.
Note:
The dimmer will enter Advanced Programming Mode
–
Continue to Hold for the remainder of the 15 seconds
3. Load (light) will turn OFF and turn back ON to full intensity. This represents a successful factory reset.
Note:
• If you perform the factory reset sequence, you will default your APM settings and may need to adjust Low-End
Trim settings to accommodate your particular bulbs.
• While restoring factory defaults the dimmer will enter Main Menu Mode
–
Continue to hold the Tap button for
the remainder of the 15 seconds.
5
sec
15
sec
T
T