5
www.Lumishore.com
Lumishore UK Unit 3, Technium 1, Kings Road, Swansea, SA1 8PH, UK | +44(0)208 144 1694 | [email protected]
Lumishore USA 7137 24TH Court East Sarasota, Florida 34243 | (941) 405-3302 | [email protected]
Entering Light Setup Mode - First Time Discovery
2
Step 1
Step 2
Step 3
Go to Preferences
Select Light Setup Mode. If this is a new setup,
the Controller will then enter “Discovery” mode
where it searches for connected lights.
To “Add” lights or “Modify” an existing setup - see
next section.
The controller will detect how many lights are
connected and then display the result on the
screen. Check if the number of lights matches
the number of installed lights, if not please
refer to the troubleshooting guide at the back.
Step 6
Step 7
The second light discovered will start to flash
a color sequence of “Blue , Green and Red”
Again using the rotary dial, change the light
position of this light to match its position on
the vessel.
Repeat these steps until all lights have been
assigned the correct position.
Press “Save” to store the lights in the
controller memory.
Step 4
Step 5
The first light detected will then start to flash
a color sequence of “Blue, Green, Red”.
Note: Lights are discovered in a random order.
The position of the light is not yet assigned so it
may be at any installation point on the vessel.
Use the rotary dial to change the number
to correspond to its correct position on
the vessel and press again to confirm.
Press next light to continue with
the setup
4
2
4
1
2
3
5
1
4
3
5
8
5
5
5
5
