Ludlum Measurements 3003, Руководство пользователя

Страница: 31 / 89

Model 3003 and 3003i Multi-Detector Survey Meter / SCA
Section 4
Ludlum Measurements, Inc. Page 4-1 September 2020
Setup Mode
Warning!
Only advanced users or administrators should consider changing any of
the parameters in the following section. Incorrect settings could
jeopardize the safety of users depending on this instrument.
Setup Overview
Your instrument has been shipped from Ludlum Measurements only after
passing electronic checkout, a 24-hour burn-in process, and a careful calibration
process. Calibration papers are supplied with each instrument shipped from
Ludlum Measurements.
Recalibration should be accomplished after a predetermined calibration
frequency (Ludlum Measurements, Inc. recommends no more than a one year
interval), or when the operation of the instrument is suspect, or maintenance has
been performed on the instrument. Recalibration is not normally required
following instrument cleaning or battery replacement. While recalibration does
not require any special tools or software to perform, Lumic software available
through Ludlum Measurements, Inc. will greatly ease calibration especially when
second order deadtime correction (extended calibration) is being utilized. As a
result, the use of Lumic software is highly recommended.
Ludlum Measurements offers a full-service repair and calibration department.
Not only do we repair and calibrate our own instruments, we also service most
other manufacturers’ instruments. Calibration procedures are available upon
request for customers who choose to calibrate their own instruments.
Note:
Ludlum Measurements, Inc. recommends recalibration at intervals no
greater than one year, assuming that regular operational checks are
performed. Check the appropriate local, state, and federal regulations to
determine required recalibration intervals.
Section
4