The 8400-Series Voice Terminals Instructions for Installation, Switch,
Administration, and Programming the Options
555-015-725
Issue 1
October 1996
Programming the Options
Page 7-7
7
■
After pressing “1” or “2”
or
pressing “#”, the red and green lights stop
fluttering and one of the following voice terminal responses occurs:
If the voice terminal saves your selection, the first three green call
appearance lights go on and, if you have a display, a confirmation
message is displayed.
If the voice terminal cannot save this selection, the first three red call
appearance lights go on and, if you have a display, an error
message is displayed. In this case, the selected option will be in
effect until power is removed from the set. If this happens, try
repeating the process. If the option still cannot be saved, the
terminal may be faulty.
Enabling/Disabling the Status Lights for the
Analog (Tip/Ring) Adjunct Interface
(For the 8411 Voice Terminal Only)
If an Analog Adjunct has been connected to the Analog Adjunct jack on the rear of
the 8411 voice terminal, the user can use the lights next to Button #10 (the last
button in the second column) to see the status of the Analog Adjunct connection.
These indications show:
■
Status of the ringing signal being sent from the voice terminal to the Analog
Adjunct) (on OR off)
■
Switchhook status of the Analog Adjunct (off-hook OR on-hook and idle)
■
Status of the I-Channel (used by the Analog Adjunct OR by the 8411 voice
terminal)
For a more detailed list of Analog Adjunct (Tip/Ring) status light indications, see
“PassageWay and Analog Adjunct Status Indications on the 8411” in Chapter 3:
Installing Your voice Terminal in this manual.
To enable or disable the status lights for the Analog Adjunct interface:
1. While on-hook, press
.
■
The light next to
goes on.
2. Press .
■
The light next to
goes off.
3. Enter the 2-digit code, “25” (“AL”).
■
The red and green lights next to Button #10 flutter.
■
The current setting (ENABLE T/R STATUS LAMPS or DISABLE
T/R STATUS LAMPS) is shown on the display, if there is one.
4. Press either”1” or “2” to change the setting:
— Press ”1” to enable the status lights for the Analog (Tip/Ring)
Adjunct connected to the Analog Adjunct jack
Shift
Shift
Mute
Shift
