LSI-Robway RCI-1502 HRT, Инструкция по эксплуатации

Страница: 62 / 109

Data Logging on RCI Systems
A summary of the logging percentage Function Codes is displayed in the following
table:
Function Code Name Description Default Setting
Low Load Lift counter swl percentage to record 20.0%
Medium Load Lift counter swl percentage to record 40.0%
High Load Lift counter swl percentage to record 65.0%
Logging Percentage swl percentage to log 90.0%
These default settings would give rise to the following logging operation:
Low Load Lift Counter counts the number of lifts which produce a SWL % which
is greater than or equal to 20% but less than 40%.
Medium Load Lift Counter counts the number of lifts which produce a SWL % which
is greater than or equal to 40% but less than 65%.
High Load Lift Counter counts the number of lifts which produce a SWL % which
is greater than or equal to 65% but less than 90%.
Logger Records full configuration data of any lift which produces
a SWL % which is greater than or equal to 90%
Setting Up the Data Logger
Data logging will occur at all times the display is operational. This includes the cases
when, the over-ride is activated, the display is reporting an error and during the initial
calibration of the system.
For the Logger to operate properly the display must be fully and correctly calibrated.
However, since the logger was recording during calibration it is probably desirable to
erase the logger contents after com pleting the angle and load calibrations on the RCI
System since the logger would hav e record ed som e invalid in formation during the
calibration of the sensors.
To erase the data logger contents, simply activate the appropriate Function Code once
calibration is complete (refer to Function Codes list at the rear of the Manual for the
appropriate code).
The operator c an acc ess thre e m ore F unction Codes which control how the actual
logging of loads operates. These three Function Codes are sum marised in the
following table
Stable Load Time time during which load must stay stable in order to log
Stable Load Variation load must stay within this variation to be considered stable
Reset Time load must stay belo w the Low Load Counter threshold for this
time before the log cycle ends