LSI-Robway RCI-1502 HRT, Инструкция по эксплуатации

Страница: 23 / 109

RCI-1502 HRT Tele Boom Manual
5. Calibration
WARNING
Calibration by untrained personnel may result in corruption of sensitive
calibration data. Therefore, entry into calibration routines should only be
performed by trained personnel.
Entering Calibration Mode and Selecting Calibration Functions:
•
Make sure that the correct duty number (crane confi guration) and falls
(parts of line) are selected,
•
Insert the ov er-ride key switch into the RCI-1502 Switchbox and turn it on,
make sure that the O/RIDE indicator on the front panel is lit,
•
Press and hold the SETUP button for about 2 seconds,
•
The TOP window should show F-xx, where xx is the last calibration function
performed or 00 if this is the first time you entered calibration mode,
•
Once calibration mode is entered use the UP/DOWN keys to ramp through
the calibration functions,
•
When the correct function cod e is shown in the TO P window press the
ENTER button to select that function,
•
To exit calibration mode either select F-00 or press the CA NCEL key until
the F-xx code is cleared from the TOP window.
Tools/Items Required for Calibration:
• An accurate angle finder for calibrating boom angle sensor
,
• An accurate tape meter of at least 100 ft. long (30.5m) for verifying radius,
• Known test we ight of at least 75% of the hoist rope single linepull for
calibrating the heavy load,
Note: For twin winch cranes, two test weights may be required, one for
each winch if different linepulls.
• Software configuration sheets and func tion codes list prov ided at the back
of this manual.