LSI-Robway RCI-1502 HRT, Инструкция по эксплуатации

Страница: 27 / 109

RCI-1502 HRT Tele Boom Manual
5.2. Configuring User Variables
LSI-Robway stores the load-charts, crane geometry, default alarm and motion control
settings, default da ta logging parameters, fine-tuning settings, and other useful user
variables in the memory of the RCI-1502 at the time of manufacture. As this
information may vary from crane to crane, even if they are of the same model, the RCI-
1502 allows the installer to change these variables on site. Thes e user variables
include dimensions such as slew-offset, maximu m falls for main/aux winches,
maximum line-pulls, sheave diameters, etc.
The actual values of these variables are printed on a configuration sheet (see Section
8.4. “RCI System Crane Configuration Sheet / Duty Listing” at the rear of the manual).
A copy of this sheet is also supplied separately with the system.
To v erify or change the current value of any of these user v ariables follow the
procedure below:
•
Enter calibration mode,
•
Select the correct function code from the listing then using the UP/DOWN
keys ramp to that function code and press ENTER,
•
If you want to change the v alue use the UP/DOWN key to select the new
value then press the ENTER key,
•
If you only want to verify the current v alue press the CANCEL key when
finished viewing,
•
Now you should be back at the F-xx prompt and can continue on with the
next operation.
Please note that the value of these variables is very important as they
affect the safe operation of the RCI-1502 indicator. Therefore the values of
the user variables must be checked and corrected if necessary before
proceeding with further calibration or operation.
5.2.1. Exit Calibration Mode (F-00)
Use this function to exit Calibration Mode. Alternatively, exiting calibration mode can
also be do ne by pressing CA NCEL button when on a function code other than F-00.
Ensure that dashes (----) are shown on the bottom wind ow before pressing CANCEL
button to exit.
5.2.2. View Calibrated Main Load (F-01)
The calibrated Main Winch load can be verified on normal operating mode (operator’s
screen). This function is used to view the main calibrate d load while still in calibration
mode. This is useful when just verifying accuracy of the load readout and the
calibration has not yet been finalised.
5.2.3. Calibrate Light Main Load (F-02)
Please see Section 5.5.1. “Calibrating Light Main Load” for details.