LSI-Robway RCI-1502 HRT, Инструкция по эксплуатации

Страница: 36 / 109

RCI-1502 HRT Tele Boom Manual
5.5. Calibrating Load on the MAIN Winch
5.5.1. Calibrating Light Main Load
•
Safely lift a light, known test load off the ground, the load should be
heavy enough to produce approx imately 10% of the maximum
single linepull of the main winch (or if not available, just lift the
empty main hook block),
•
Enter calibration mode, if not already activated, and select the
correct function code (F-02) for calib rating a light load on the main
winch,
•
Use the UP/DOWN keys to ramp the display to the required value,
i.e. the total weight of the light load lift ed (or if not av ailable, the
weight of the empty main hook block),
•
Press ENTER to accept value. Proceed to next Section 5.5.2.
“Calibrating Heavy Main Load”.
5.5.2. Calibrating Heavy Main Load
•
Safely lift a heavy, known test load of f the ground, th e load should
be heavy enough to produce approximately 75% of the maximum
single linepull of the main winch,
•
Enter calibration mode, if not already activated, and select the
correct function code (F-03) for calibrating a heavy load on the
main winch,
•
Use the UP/DOWN keys to ramp the display to the required v alue,
i.e. the total weight o f the heavy load lifted (including the weight of
the main hook block and all rigging accessories used),
•
Press ENTER to accept value. For Twin Winch cranes, proceed to
Section 5.6. “Calibrating Load on the Aux Winch”.
Verify that the MAIN LOAD is accurately measured, using the VIEW
CALIBRATED MAIN LOAD (F-01) function.