Gen VI Dimmer
User Manual
Page 9
Press a channel number
to toggle its mode between “Dimmer” mode and “TruPower” (switch) mode.
A light grey button indicates dimmer mode and a dark grey button indicates TruPower mode as
shown in the “Legend”.
Configure your channels then press
Save
.
Note: Changing a channel from TruPower to Dimming mode can potentially damage connected
equipment that should not be connected to a dimmed output. If you change a channel from TruPower
to Dimming you will be asked to Confirm your changes.
2.2.2
Auto Power
Channels configured for “Auto Power” are switched on when a valid DMX signal is detected on the
input to the GEN·VI, regardless of actual DMX levels. When the DMX signal ceases, the channels
will switch off after a user programmed time.
“Auto Power” can only be selected if the channel is set to “TruPower” mode. See above.
To set a channel to “Auto Power” mode, select
Config
,
Channels
, select the channel number(s)
then select
Edit
and
use the “Parameter Selector” buttons to select the “Source” parameter.
Once “Source” is selected, the choose
Auto Power
then select
Apply
.
Control of all
“Auto Power” channels can be disabled or enabled.
From either home screen press
Config, DMX
.
In the “Auto Power” pane press
Disable
. When disabled, the button becomes
Enable
.
Press
Hold Time
to set the time that the “Auto Power” channels will stay ON after the DMX signal is
lost.
Parameter
Selector
Parameter
Selector
“Source” Parameter
Auto
Power