Gen VI Dimmer
User Manual
Page 12
4
Installation
4.1
Safety
All electrical work must be carried out by suitably qualified persons.
4.2
Unpacking
The GEN·VI dimmer is fully tested and inspected before leaving the factory. Upon delivery, inspect
the dimmer for signs of damage or mishandling. In the event of any damage, contact your LSC agent.
4.3
Installation
4.3.1
Rackmount GEN·VI
The Rackmount GEN·VI is designed for mounting in a standard 19 inch rack. It occupies 3RU (Rack
Units) of space. Provide adequate support for the dimmer. The dimmer weighs up to 21Kgm
(depending upon the model). The ventilation holes on the sides of the unit must be kept clear.
4.3.2
Wall-mount GEN·VI
The wall-mount version is comprised of two sections. The front section (containing all of the
electronics) is attached to the rear section by two hinges located at the bottom and the front section
can be completely detached from the rear section to allow better access to the mounting points and
the supply and load cable terminations. This also allows the rear section to be mounted and
connected whilst the front section is safely stored until all other trades have completed their work
and the area is safe and clean. The front section can be opened by removing the 4 large screws as
indicated below.
Remove two large
screws to open
Slip Hinges
underneath
Remove two large
screws to open