Louet Megado 110, Инструкция по эксплуатации

Страница: 8 / 43

6
Apply pressure to the side where the
foot rail pegs rest so that the side
moves out, allowing the pegs of the
foot rail to fall into place.
Connect and tighten at both sides with
m8 x 70 mm bolts, large washer, and
barrel nut.
Since the loom can now stand on its
own, remove the trestles or whatever
you have used to support the middle
section.
Next, assemble the wide cross member
between the two vertical posts at the
rear of the middle section:
Take four m6 x 70 mm bolts from the
hardware bag and place them complete
with their washers into the four holes of
the middle posts
Take the wide cross member out of
Box C. You can recognize this cross
member by the four barrel nut holes at
either end.
Slide the cross member on one side
onto the m6 x 70 mm bolts that
protrude on the inside of the middle
post.
Then place the cross member between
both middle posts and push the bolts
into the holes to find the right position.
Insert the barrel nuts and tighten the
bolts.