Louet Megado 110, Инструкция по эксплуатации

Страница: 21 / 43

19
Screw the hinges into the bottom of the
uprights. The exact height of the beater
can be adjusted later on by screwing
the hinges further in or out.
Attach the reed support (out of Box D)
in the notches of the uprights, using the
two m6 x 75 mm bolts, washers, and
barrel nuts.
Place the entire assembly, uprights and
reed support onto the loom. By keeping
the assembly slightly tilted, you can
guide one hinge around the side rail
first and then the other.
Place the hinges into the grooves on
the lower side rails.
Slide a washer onto both lag screws
and insert the lag screws into the holes
in the top beater bar. If applicable,
choose the nicest side facing the front
(the side of the handle).
Slide a washer and a steel bushing
onto both lag screws.
Turn the screws into the handle until
the bushings fit tightly against the
handle.
Insert the carriage bolts m6 x 80 mm at
the front (the side of the handle)
through the holes in the end of the
beater bar and slide on the washers.
Screw the wing nuts onto the bolts a
couple of turns.