Louet Megado 110, Инструкция по эксплуатации

Страница: 16 / 43

14
Insert the m8 x 50 mm carriage bolt
through the back post after you have
lifted up the back part of the loom (to
prevent the hinged arm from interfering
with the installation of the carriage
bolt).
Slide the large washer, bushing, and
small washer onto the bolt and tighten
with the cap nut. Later on the brake
cable will be installed onto this bolt.
Insert the m8 x 75 mm carriage bolt
through the lower hole in the back post
and slide the large washer and bushing
onto it.
Tighten the cap nut and have the
square part of the bolt head cut into the
wood. Take the cap nut off again.
This bolt is the shaft for the brake
pedal.
Take the brake pedal out of Box B.
Hook one end of the spring onto the
eye of the pedal and the other end to
the eye in the back post. Slide the hole
in the brake pedal over the bushing
onto the bolt.
Slide the small washer over the bolt
and tighten with the cap nut.