Louet Megado 110, Инструкция по эксплуатации

Страница: 24 / 43

22
2. Assembling the dobby treadle
Screw the guide block for the dobby
treadle with the two 5 x 55 mm screws
into the pilot holes on the inside of the
right hand front post of the loom.
Insert the dobby treadle from the right side through the brace of the previously installed guide
block. Watch out for the proper position of the treadle with respect to the parts that have
already been attached to the treadle (see picture next page).
The m8 x 70 mm bolt is the hinge point for the treadle: Turn the barrel nut off and take only
one washer from the bolt. Insert the bolt with one washer and bushing through the hole in the
treadle and replace the first washer.
Insert the barrel nut into the hole in the front post on the left side of the loom and attach the
treadle by screwing the bolt into the barrel nut.
A support for your foot can be attached
onto the foot rail.
3. Installing the blocking block
Use a book or two to make a stack at
least 1" (2.5 cm) high and slide them
underneath the right side rail while you
lift the loom on that side.
A threaded m8 end with two large
washers, a small washer, and a cap nut
have been assembled in the blocking
block.
Take off the nut and one of the
washers from the threaded end.
Insert the threaded end with the
blocking block into the hole at the
bottom right hand side rail.