Louet Megado 110, Инструкция по эксплуатации

Страница: 6 / 43

4
Take one of the hinged arms and assemble it to side rail JND, using an m8 x 65 mm carriage
bolt, washers, and cap nut. Make sure that the screw hooks of the arm are located as shown
on the picture. One big washer and two small washers have to be placed onto the bolt
between the arm and the ball bearing; the two small washers facing the bearing. No washer
is required between the cap nut and the other ball bearing.
Assemble side rails JND and IMC each
with two m8 x 50 mm carriage bolts,
large washer, and cap nut to the middle
section. The front connections of the
side rails to the middle section are
marked M-M and N-N.
Assemble the other hinged arm to side
rail IMC in the manner described
above.
Put the two remaining m8 x 65 mm
carriage bolts into the remaining hole of
each hinged arm and add the washers
and cap nuts. Place the hinged arms
with the carriage bolts on the side rails,
as shown in the picture.
2. Assembling the side parts of the frame
Take the middle posts AC and BD and
slide these onto the wooden pegs of
the side rails (connections C-C and D-
D). For both connections use an m8 x
130 mm bolt with large washer and
barrel nut.
Take the lower side rails AE and BF
and the front posts LJHF and KIGE and
attach the rubber buffers by screwing
them into the threaded holes.