Louet Megado 110, Инструкция по эксплуатации

Страница: 27 / 43

25
Remove the plastic hooks from the
cord ends. Slide these ends through
the back into the holes of the reversing
disk. Replace the plastic hooks and
press them into the black holders on
the disk, the tips of the hooks pointing
towards the bottom of the groove.
Turn the disk in position so that the
longest cord comes from the upper
hole.
Guide the cords around the back of the
beater upright and over the two pulleys
of the angled pulley bar. The longest
cord from the top of the disk should run
over the top pulley.
Guide the cords over the other pulleys,
as seen on the picture. The anchor will
then be properly placed up against the
rollers behind the knob.
Slide the pulley bar so that the cords
beside the bar run parallel and screw
the remaining screw into the hole of the
pulley bar and fasten the bar in its
proper position. Now tighten up the cap
nut of the pulley bar completely.
7. Adjusting the tension of the cords
The reversing disk is held in position by the two cords that connect the disk to the anchor. If
these cords are taut, the free play of the disk corresponds with the play of the anchor. In rest,
the two cords will always have the same tension. If you tighten one of them, the position of
the disk will alter a little and the increased tension will be divided over both cords.
You can adjust the cord tension by turning the knurled nylon nuts, or inserting the hooks into
the next cord loop.
To get an impression of the needed tension, just touch the shaft cords, by way of example, at
the bottom of the shaft section of the loom. The tension on the cords to the anchor may be a
bit more.