LORAD AFFINITY Series, Руководство по обслуживанию

Страница: 133 / 214

P/N 9-500-0255 6-5
Service Manual
Chapter 6: Maintenance—Remove and Replace Procedures
Gantry Components—Remove and Replace
2.1.3 Rear Connector Panel
The connector
panel (Figure 6-2,
Item 4) on the
lower rear side of
the Gantry, houses
the connectors for
the Footswitches
and accessories.
Removal of this
panel is only
necessary when
replacing a
connector or when
removing the
lower rear panel
(Figure 6-3, Item
3).
1. Remove the
upper rear
panel as per
Section 2.1.2.
2. Remove the
four screws
that secure the
shroud (Figure
6-3, Item 2) to
the standoffs on the upper rear panel.
3. Remove the four screws that secure the rear connector panel (Figure 6-3, Item 1)
to the Gantry Frame.
4. Pull the panel away from the Gantry, then flip it down to gain access to the
connector mounting hardware.
5. Reverse these procedures to replace the panel.
2.1.4 Lower Rear Panel/Power Distribution Assembly
The lower rear panel (Figure 6-3, Item 3) which is part of the Power Distribution
Assembly chassis, provides access to the isolation transformer and the C-arm
actuator assembly. The panel and Power Distribution Assembly chassis slide out of
the unit together.
The Power Distribution Assembly chassis has an upper and lower shelf. The isolation
transformer is mounted on the lower shelf; the input power filter, Relay Protection
Board, and transformer tap panel are on the upper shelf. Before proceeding, ensure
power is removed from the unit.
1. Remove the upper rear and connector panels as per Section 2.1.2 and Section
2.1.3.
2. Remove the six screws that secure the panel to the Gantry frame.
3. Pull the panel, which is attached to the input power assembly chassis, out of the
Gantry approximately halfway.
Figure 6-3: Rear Connector and Lower Rear Panels—Removal