t
t
h
h
e
e
r
r
m
m
o
o
c
c
o
o
m
m
f
f
o
o
r
r
t
t
P
P
N
N
A
A
1
1
5
5
/
/
2
2
0
0
/
/
2
2
5
5
/
/
3
3
0
0
Lohberger Heiztechnik
GmbH
Operating Instructions
N29/HB/GB
page 44
Lohberger Heiztechnik GmbH, A-5020 Salzburg-Bergheim, Rechtes Salzachufer 40
Tel. 0662-450444-0, Fax-DW 9
Es gelten unsere aktuellen allgemeinen Geschäftsbedingungen. Irrtum, Druckfehler und technische Änderungen vorbehalten
NOTICE 18 „IF THIS NOTICE DOES NOT DISAPPEAR: Please switch off power for at least 5sec.!“
While the network reinitializes (= restarts) with a new bus device (bus module or the digital room
unit), it can cause a system failure (the program will "hang up").
WHAT TO DO? Is this notice not deleted after 10 seconds after you have started a bus device, de-
energize the system for at least 5 seconds. A few seconds after starting the system, it automatically
calls up the previously displayed menu frame, usually the bus device is properly connected then.
NOTICE 19 “BUSMODULE 1 DOES NOT RESPOND! Check electric wiring and the busadress
setting!“
Displayed if the communication boiler – bus module 1 does not work after activation in the menu
frame "Start busmodule´s".
WHAT TO DO? Follow the notice instructions.
NOTICE 20 “BUSMODULE 2 DOES NOT RESPOND! Check electric wiring and the busadress setting!“
Displayed if the communication boiler – bus module 2 does not work after activation in the menu
frame "Start busmodule´s".
WHAT TO DO? Follow the notice instructions
NOTICE 21 “BUSMODULE 3 DOES NOT RESPOND! Check electric wiring and the busadress
setting!“
Displayed if the communication boiler – bus module 3 does not work after activation in the menu
frame "Start busmodule´s".
WHAT TO DO? Follow the notice instructions
NOTICE 22 „The settings are taken over by the roomdevice after POWER OFF/ON“.
Displayed if menu frames “basic set. dig. room un. HC 1“ to “basic set. dig. room un. HC 6“ are
exited.
WHAT TO DO? If settings were changed, restart system (de-energize for min. 5 sec)
8.3
List of questions
QUESTION DID YOU FILL LOGS? YES(+) NO(-) – not for PNA
This is a request – please answer!
It is displayed if "Pellet/Logs operation" is preselected in menu frame "Fuel selection" and both
burners are in standstill once the door has been closed after it was opened for more than 10s.
Push the appropriate button with the text "YES" or "NO".
If "Yes" has been selected, the log start follows immediately after ignition in pellets start (thus, the
detection duration and the corresponding smoke phase is shortened by several minutes).
8.4
List of ERROR reports
ERROR 10 „Power cut!“
Triggered after switching on the supply voltage to register the power cut in the report memory
(required for potential error analysis).
WHAT TO DO? Nothing.
ERROR 11 currently not available!